RDH
Fractal Fanatic
Thank you!When you save a preset, it saves all channels in all blocks of the preset. Same as always.
Thank you!When you save a preset, it saves all channels in all blocks of the preset. Same as always.
That link only takes me to a blank page. I assume it will show up on the fractal site's download page eventually.
And thank you to our beta team members for not only converting but enhancing the presets in Banks B and C!
Nope.i think recto modern got a MV pot taper update, it doesn't start breaking bad until 5ish now...sweet spot is up near 3.5...brb, going to smash some furniture...
Yes I haveHas anyone else noticed how much better the low end is now? I know I might be late on this, but I usually wait to firmwares come out of beta to flash them. I was tweaking my 5153s patches last night, and just DLed firmware 11 and the lowend is so much more massive an fuller. I actually had to turn the bass down on my presets, something which I never have to do on the 5153s. It is so awesome!
in Global Settings.Where do I find the Global “Update Pre-11.x Presets Spkr Imp Upon Load" in Axe Edit?
It’s there.That was the first place I looked. I’ll take another look.
If you have turned on the global parameter, the speaker impedance will be applied as soon as you load a preset. If you do not save the preset, it will remain stored without the speaker impedance. But no matter, because as long as you keep the global parameter turned on, it will keep loading with the new speaker impedance. Every time.Hi
So I will try and install these two Christmas presents we have in advance , firmware and factory banks ...
So a question of .... global understanding ....
I want ALL my presets to benefit of the new curve parameter ..... if I set the global parameter , do I have also to select each preset to load the new curve parameter ..... and the then save the preset with it .....???
how do you proceed to have everything..... in your axe to to benefit of the new and dedicated curve ....even if I know that a few amps do not actually have their own curve ..
Thanks !!!!!!!!
Thanks for your answer Rex ,If you have turned on the global parameter, the speaker impedance will be applied as soon as you load a preset. If you no not save the preset, it will remain stored without the speaker impedance. But no matter, because as long as you keep the global parameter turned on, it will keep loading with the new speaker impedance. Every time.
If you save the preset after the speaker impedance is applied, then it doesn’t matter what the state of the global parameter is, because the preset has already been saved with the speaker impedance applied.
To add to @Rex.Hi
So I will try and install these two Christmas presents we have in advance , firmware and factory banks ...
So a question of .... global understanding ....
I want ALL my presets to benefit of the new curve parameter ..... if I set the global parameter , do I have also to select each preset to load the new curve parameter ..... and the then save the preset with it .....???
how do you proceed to have everything..... in your axe to to benefit of the new and dedicated curve ....even if I know that a few amps do not actually have their own curve ..
Thanks !!!!!!!!
Then I suggest not installing the new version 11 presets and follow what @Rex said. Then you can go back and forth and decide what you like better.Thanks for your few words ,
For the moment I m interested to hear how sounds the new factory presets , the modifications they had and also to compare the impact of the new impedance curve parameter on my presets from 10.02 .....