Had a tinkle here
If the amps need to be reset, the release notes will specify resetting them, correct?
Yes.If the amps need to be reset, the release notes will specify resetting them, correct?
What was the CPU % for that preset? When usage is 80+% the system can get starved and that can affect the UI and sound processing.Display looks great! Both installs done.
However, since this install I have had a lot of occassions where either both FM9Edit and the FM9 froze for a while, or that there is a big delay in switching scenes (resulting in change to scene in sound and no change on board, no change in scene and sound, ...). Anyone else have the same experience?
It doesn’t show that. The main display only shows the current preset, the scenes and which one is selected. There’s not enough screen space in the main display to be able to add that additional information.does it show the bybass/channel state in bigger font on the bottom of the screen as well? If not that would make it perfect if it did.
I have tweaked to 75% and indeed everything works fine now, thanks Greg! ;-)What was the CPU % for that preset? When usage is 80+% the system can get starved and that can affect the UI and sound processing.
I target 75%. Some presets run closer to 80% and then I try to find something to adjust to drop it down again.I have tweaked to 75% and indeed everything works fine now, thanks Greg! ;-)
Right I get all that but on the screen when you bypass a drive for example it'll say drive bypassed, when you enable it it'll say drive enabled. When you switch channels it's say drive Chan B would be cool if that font you see at the bottom of the screen were to be a bit bigger as well. Just because sometimes I'm not focusing on what the strip says. It's a nit pik but just nice to have options. That's all.It doesn’t show that. The main display only shows the current preset, the scenes and which one is selected. There’s not enough screen space in the main display to be able to add that additional information.
Bypass and channel state are reflected by the switch rings and only apply to individual blocks. You can tell the modeler to add channel information to the mini-displays; see p. 9 in The Footswitch Functions Guide.
For example, I use channels on a drive block for different drive models, and assigned the hold function of that drive’s bypass switch to incremental the channel and set the display to show the block name and the current channel.
Ah, it sounded like you wanted all blocks to display their state.Right I get all that but on the screen when you bypass a drive for example it'll say drive bypassed, when you enable it it'll say drive enabled. When you switch channels it's say drive Chan B would be cool if that font you see at the bottom of the screen were to be a bit bigger as well. Just because sometimes I'm not focusing on what the strip says. It's a nit pik but just nice to have options. That's all.
Ah, it sounded like you wanted all blocks to display their state.
Yes, the temporary status font size could probably be changed too.
Had a tinkle here
Had a tinkle here
Had a tinkle here
Your not kiddingOn the other hand the improvement on the speaker thump is definitely not subtle, turn it to 4 or 5 and you'll have a real cab coming out of your monitors