Pressing Setup shows that it is a beta but strangely, not which version. Seems like it could be an easy change to show it there.Is there any way to tell which Beta version you have installed?
I can't duplicate that.I've noticed there are 2 x Carol-Ann Triptik Clean amps available ?
Does anyone else have this ?
Axe Edit -> AMP BLOCK -> SELECT and then you should see them in the menu (numbers 076 and 078)
I've been noticing the popping noise in the drive block when I am using the eq dials. When I double click them to set the bass freq to 200 hz and the treble to 10k hz it pops. I've heard on the TS 808 and the Horizon PD pedals.
This response is a much better use of forum space. As is my response to your response. Clearly.Fussing so over boot time seconds/speed etc. = YAWN!!!!!!!!!!!!
Seriously folks,...how trivial and what a waste of forum space and everyones time....Donchathink?
How about that beta...huh?
Careful with the forum space guys, we don’t want to run out.This response is a much better use of forum space. As is my response to your response. Clearly.
You beta watch out
You beta not cry
You beta not pout
I'm telling you why
Santa Claus is coming to town
Ok this was pretty ridiculous as advertised. Jammed on this for a bit for great fun.Texas Star Clean sounds utterly amazing. I paired it with the Legacy 105 (Rumble EV12L RNR1) and Legacy 106 (Rumble EV12S M160) and with the gain on 5, a FET boost in front, big dual delay and the South Church Reverb I can sit here for hours noodling away.
Those Rumble cabs go with just about anything, I'm using them with the Plexi 50W Normal and the Dumble amps and they just seem to work. Dialling in epic tones has never been easier than with Cygnus, top marks to Fractal for this and thank you very much.
EDIT
Attached a copy of the preset - if you have active pickups, switch the CC Boost off in the amp block preamp section.
I was looking at this and it shows in Axe Edit 076 Triptik Clean, 078 Tucana Clean. Maybe you should Refresh the Software.I've noticed there are 2 x Carol-Ann Triptik Clean amps available ?
Does anyone else have this ?
Axe Edit -> AMP BLOCK -> SELECT and then you should see them in the menu (numbers 076 and 078)
I was looking at this and it shows in Axe Edit 076 Triptik Clean, 078 Tucana Clean. Maybe you should Refresh the Software.
I’m already showering with my neighbors wife to save water- now I gotta conserve forum space too?Careful with the forum space guys, we don’t want to run out.
You can be more efficient, use both sides of the toilet paper.I’m already showering with my neighbors wife to save water- now I gotta conserve forum space too?