Hi Scrutinizer. Lesson needed here please . I have almost succeed to control Axe from physical Midi controller via Lemur, with the method described above by you. In my case I try to remote just preset increase button (UP arrows below SEND). The problem is that it works just one time... When I send CC22 for UP - with value 10 it sends correctly UP command from LEMUR to AXE, Axe - responds correctly, however UP button in Lemur changes from white to red and does not responds anymore, till I put it back to “white” but by touching Ipad screen.
What am I doing wrong?
It works If I set my controller to send CC with value 0 during second press of button -> then it goes back to white and responds correctly to next press of button - but that’s not the way I like it to work.
If I set my controller (FCB1010 Behringer) to send first CC22 with value 10 then immediately value 0 the Lemur and Axe does not responds at all maybe both CCs comes to quickly one after the other...
Any hint please?
Thanks once again for this excellent templates!
What am I doing wrong?
It works If I set my controller to send CC with value 0 during second press of button -> then it goes back to white and responds correctly to next press of button - but that’s not the way I like it to work.
If I set my controller (FCB1010 Behringer) to send first CC22 with value 10 then immediately value 0 the Lemur and Axe does not responds at all maybe both CCs comes to quickly one after the other...
Any hint please?
Thanks once again for this excellent templates!