Ok so I finally hooked my axe fx to my Dumble using Yek's amazing presets. I hooked fx out of Axe into return loop on amp.
When i am in the return all controls of the amp have no effect as the signal is routed straight to the power tubes
It sounds awesome for the most part.
My problem is volume variance between presets.
I noticed on the fx block the gain on the second page usually set -80db doesn't seem to do much?
What is the best way to customize each patch for volume? Should I alter the level in Amp setting?
or adjust the main slider in the fx block, finally how do all these changes work with the output knob 2 on the front of the axe?
Example when I select the plexi 100 watt preset I was blown across the room and down the block. Turning down the volume on the front of the
axe seems to help but with other presets not as much?
Also realized this is what I have been missing all along as I was not happy with the sound going through my RCF's
Will be ordering a matrix gf1000 soon as it will probably work better than using the effects loop of my guitar amp.
Whats the difference of using a fx block vs just hooking up output two to the return? If I am bypassing the cab IR and output simulation globally?