Not sure if this is a possible bug in Firmware 7.0 or if I am missing something, but I wanted to post it here to see if anyone else was having the same issue. When I go to Setup->I/O and page to the Pedals page, I only see Pedal 1 and Pedal 2 listed. I have 3 pedals connected and I'm pretty sure I calibrated all three before updating to the latest firmware. Now I am unable to calibrate Pedal 3 because it is not listed at all. I know the pedal is correctly connected because if I choose Pedal 3 in the Modifier menu of any parameter in Axe-Edit III, I can see the yellow dot on the graph moving when I move Pedal 3 and I can control parameters with it. Is there somewhere else to calibrate Pedal 3 from the front of Axe-FX 3 or is this a bug in the Firmware 7.0? Thanks for any feedback on this issue!