jefferski
Fractal Fanatic
I figured you meant it was a short and sweet video... ;-)I had some fun playing with the new flanger....
I love that song.
I figured you meant it was a short and sweet video... ;-)I had some fun playing with the new flanger....
That's not how I recall Cliff describing the behavior of this parameter... But I've been wrong beforeWhenever you write information to a preset, you've edited it — even if you wrote the same information that was already there.
Your Axe-Fx is set to update the speaker impedance curve whenever a preset is loaded. That means information gets written to the preset. It doesn't matter that it's the same information that was there before. So the "Edited" light gets turned on.
How do you remember it?That's not how I recall Cliff describing the behavior of this parameter... But I've been wrong before
See the edit to my last post - we crossed in the etherHow do you remember it?
I just confirmed the same thing on the current beta.I just confirmed on my Axe Fx (still on 11.01) that with the parameter set to Yes, when I load a preset that I have saved since the option was added that the Edited light does not come on. If I change to a preset that was not updated then the light does come on.
Understood. My understanding was that it only auto-edited presets made before FW11.0. These presets were made before 11.0, but had been edited and saved after 11.0. I thought that since they had been updated after FW11, they would no longer be auto-edited.Whenever you write information to a preset, you've edited it — even if you wrote the same information that was already there.
Your Axe-Fx is set to update the speaker impedance curve whenever a preset is loaded. That means information gets written to the preset. It doesn't matter that it's the same information that was there before. So the "Edited" light gets turned on.
What happens when you save a preset under the new firmware? Does the Edited light still come on”That’s how it worked for me on 11.01, but with current beta, the presets are showing as edited. If I were at my computer I’d upload one of them.
Thanks! Any info on what mods you did to the Trainwreck for the new model?
Just played for over an hour...sounds and works wonderful on my patches/settings. Love the new flanger options. The only thing I noticed is the Volume block does not reset to 10.00 when I change patches (it sets to something like 9.54), even though it sound like it's on 10.00 when my volume pedal is fully engaged.
Tremolo run!!
Looking forward to messing with the flanger tomorrow.
No, that's new.Maybe i missed it but it seems a Low and Hi Cut is now present on the Env Follower controller, was it there before ?
But not advertised?No, that's new.