That Brit 800 #34 and my Edge Strat?
I THINK this is what I had - not sure what verb settings as I didn't save the presets....
Edge Strat has a humbucker in the bridge...this is on pos 1 with the vol at about 7 and the tone down a notch.
A good thing? I guess that's better than bunkerballs...but ... ?This is absolutely bonkerballs.
Sounds very good (The Edge Strat has got original a fat Duncan Singlecoil?).
Interessting that you´r using your knobs on guitar to make this sound - but it show, how good the new Firmware/Algorhythm reacts with the guitar.
It's amazing! I know everyone's talking about the chug, but the dynamics in this clip are incredible. That pop on the initial pick attack and how it cleans up so well at around 0:08 - 0:10 when you pick lighterA good thing? I guess that's better than bunkerballs...but ... ?
Yes, the dynamics control just from varying pick attack is clearly evident in this clip. Can't wait to be done moving. Painter shows up in about an hour. Movers show up @ the old place to pack on Thursday, and to load up the truck and move all our stuff on Friday. Then starts the prep for selling the old place. Hoping for a bidding war. Lots of California folks buying in that area, and paying above assesed value. If I do well on the sale, the new place could possibly be paid for by the old one. More $$$$$ to buy Fractal goodies and guitars! I can't wait to assemble the new music room in the larger of the two non-master bedrooms and be able to finally check out the new Cygnus goodies....It's amazing! I know everyone's talking about the chug, but the dynamics in this clip are incredible. That pop on the initial pick attack and how it cleans up so well at around 0:08 - 0:10 when you pick lighter
first is 2, then 3Ok, what Is II and what is III in this audio?
Any insight about this?This still seems to be resetting parameters like Output EQ in Amp Block (dont know what else).
For those of us who doesnt want any changes in terms of parameter setting in the whole amp block; would Block Library copy paste or Channel Copy paste be a solution? Is it considered a soft reset to choose a different amp then the same amp and paste the older parameters?
Soft-resetting an amp and then pasting all old block parameter values doesn't make sense.This still seems to be resetting parameters like Output EQ in Amp Block (dont know what else).
For those of us who doesnt want any changes in terms of parameter setting in the whole amp block; would Block Library copy paste or Channel Copy paste be a solution? Is it considered a soft reset to choose a different amp then the same amp and paste the older parameters?
Makes sense thank youSoft-resetting an amp and then pasting all old block parameter values doesn't make sense.
This usually works well:
1. Copy the amp channel to another channel.
2. Soft-reset the amp channel.
3. Switch between the two channels and adjust the settings where desired.
Maybe truly silly question ,Soft-resetting an amp and then pasting all old block parameter values doesn't make sense.
This usually works well:
1. Copy the amp channel to another channel.
2. Soft-reset the amp channel.
3. Switch between the two channels and adjust the settings where desired.