Where is the "1968 100W Plexi" ?
Where is the "1968 100W Plexi" ?
Fixed version is up in the OP.
Never-ending I don't think so, reality comes to you when you own a Mark 1 or 2, it definitely endsThanks again for the never ending support… Amazing response times!
Set it where you like it.
The impetus was this:
Someone asked me to match a Kemper profile (one of the Top Jimi ones). I could not match the profile even with the Supply Sag all the way up. With the new firmware I can now match the profile with Supply Sag around 7.0. I've never encountered a real amp with that much sag so I don't know how accurate the profile is but that's the story behind it. Theoretically at maximum Supply Sag you get about 6 dB maximum compression. So at 7.0 you'd get about 4-5 dB which is huge (and I mean yuuuuuuge). I've never measured an amp that gets anywhere near that and it's usually around 1-2 dB. The worst I've seen is our 1968 100W Plexi where the sag measures about 2.4 dB.
I'm a little jaded by this update. I have rolled back to Q5.02. (which reports as 5.01 in Axe-Edit). When I loaded the first variant of 5.03 my class A 30 -TB reported 0.75 SAG. Now I know i never touched that parameter... and now I have rolled back to 5.02 and re-applied my backup... it states 3.00 for the SAG... so did 5.02 halve or quarter my SAG parameter???? and is this a bug or is it part of the problem that caused Cliff to pull that version of code?