nicolasrivera
Fractal Fanatic
Wow, thanks a lot!!!
The maximum amount of sag is now twice what was previously available.
NEVER use less cowbell. NEVER. . .Cool!! With more sag, maybe I can use less cow bell
Did the BB get updated?
Fixed duplicate Modifiers (left over from a bug in the original Axe-Edit) possibly not being deleted properly.
Fixed volume of “Brit Silver” amp model lower on Latest and Q2.01 modeling versions.
Fixed Preamp Bias not retained when Force Default Version is On.
Fixed wrong firmware version reported to Axe-Edit.
Re. Sag
After updating to Q5.03 I loaded a preset of mine with a 'Shiver' amp block - checked the Sag value - it was 0.80
I'm pretty sure I didn't tweak the Sag value for that amp from it's default when making the preset - so it was probably '1.60' in the previous FW.
I then changed the amp type to another Shiver type and the Sag value went to 1.60 - I then swapped back the amp type to the original amp and the Sag value stayed at 1.60 - it didn't revert to what I believe was the original 'halved' default of 0.80.
So have all the amps default Sag amount actually doubled - IE all amps have much more Sag effect applied by default?
I sort of read it as if an amp's default Sag was 1.60 in Q5.02 it would become 0.8 in Q5.03 and stay at that value - meaning you could dial in twice as much Sag if you wanted
Or am I being a dunderhead?
Something is wrong. I've pulled the firmware until it gets sorted.
link just takes me back to the fractal home page. anyone else getting this for the mark II?
Well that was the quickest turn around in the industry.Fixed version is up in the OP.