yyz67
Fractal Fanatic
AFAIK, in the current amp block speaker compression gradually kicks in only when an amp moves into OD/saturation (e.g. reduced headroom). This means that clean amps models/settings with lots of headroom don't get the benefit of much speaker compression even if the parameter is turned up to 10. I believe this is by design, however, I'd like...
WISH: A dial to be able to have clean amps have speaker compression response similar to overdriven amps. This might be akin to a virtual speaker current multiplier or offset to get the coil into saturation [but I'm talking out my ignorant butt.. I have confidence Cliff could devise something].
WISH: A dial to be able to have clean amps have speaker compression response similar to overdriven amps. This might be akin to a virtual speaker current multiplier or offset to get the coil into saturation [but I'm talking out my ignorant butt.. I have confidence Cliff could devise something].
Last edited: