mcgyver
Inspired
Did the update yesterday and noticed a few things that I didn't like. I wanted to know if anyone else has experience these issue?
I have a few clean presets that now distort and are clipping. I noticed that the clipping seems to be the cab blocks with Redwire cabs. Also noticed the new Tx star amp (Lonestar) sounds bad( harsh sound, distorts, almost like digital distortion) when you turn the gain up past 12 noon. But if you put a drive block in front of it. It distorts nicely ???? I would like to raise the gain on this for a little bite, without adding a drive block. I am sure the amp works that way ???
I didn't load Bank A after the firmware update, because all of my presets are in Bank A. Just thought I make note of that in case anyone thought this could be the cause. I did do a system reset after the firmware upgrade however. Any help would be greatly appreciated.
Thanks
Jamie
I have a few clean presets that now distort and are clipping. I noticed that the clipping seems to be the cab blocks with Redwire cabs. Also noticed the new Tx star amp (Lonestar) sounds bad( harsh sound, distorts, almost like digital distortion) when you turn the gain up past 12 noon. But if you put a drive block in front of it. It distorts nicely ???? I would like to raise the gain on this for a little bite, without adding a drive block. I am sure the amp works that way ???
I didn't load Bank A after the firmware update, because all of my presets are in Bank A. Just thought I make note of that in case anyone thought this could be the cause. I did do a system reset after the firmware upgrade however. Any help would be greatly appreciated.
Thanks
Jamie