For mixing, it doesn't matter. For live performance, every bit that can be shaved off is welcome.
Yes, sure, although I'm certainly fine with latencies higher than that, but I do understand.
For mixing, it doesn't matter. For live performance, every bit that can be shaved off is welcome.
Thanks for that. I am going to have to test it a bit as well. Latency is a HUGE factor when you run the axe along side another audio in parallel. Im eyeballing the axe to assist in voyager fx duty before i buy more pedals. If i can determine the input to output latency of the axe, I can delay my mixer input on the other parallel channel and it lessens comb filtering. Nothing new here, I have to do some wild routing when doing the same as a send/return thru my mixer and back. even 2 SAMPLES at 48k can disrupt the mix intent. My biggest fear is the axe latency isnt steady, but more of a jitter. If its fx dependent, I foresee a HUGE issue.I just tested and my AxeFx II XL has 2ms of latency from guitar input to XLR output. Just for anyone who wanted an answer to that question.
I also would like to know if the latency between switching of presets is improved or not. It is the worst point of my axe fx II, so it is really important for me. Let us know please !What about latency while switching between presets? There is a huge gap with my Axe II (first gen).
I also would like to know if the latency between switching of presets is improved or not. It is the worst point of my axe fx II, so it is really important for me. Let us know please !
It's improved - the silence gap is cut in half.
Around 50ms silence for Axe-Fx III (with the latest 1.09 beta#2) and around 100ms for the Axe-Fx II when switching between presets.
Could you post a recording of Axe-FX III preset switching while holding a note/chord?
The actual preset switching gap (silence) is well under 100 ms on the Axe-FX II.
Not here. I recorded with Reaper, measured the amount of samples in the gap switching between my presets - around 100ms that's without accounting any fade in/out, using Q 9.04 FW
Axe-Fx II latency (and thus also the III) is 1 ms.
Mr. Batio can't get there. Nor can you nor I, my brother.how many notes per second do I need to play before I start noticing it?
Petrucci notes per second or the full Angelo Batio?
how many notes per second do I need to play before I start noticing it?
Petrucci notes per second or the full Angelo Batio?
Mr. Batio can't get there. Nor can you nor I, my brother.
And I do try. My fingers get tied up in the most curious knots...it's not the succeeding, but the trying that counts... lol..
haaa.... awesome.. lolAnd I do try. My fingers get tied up in the most curious knots...