Six String Symphony
Member
I'm running OSX 10.6.8 . The Axe II shows up as a valid MIDI source in the MIDI devices window.
I am trouble shooting using MIDI Monitor.
I had a terrific MIDI setup with my the MFC101 and the Ultra - I used a MIDI interface between the MFC 101 and the Axe MIDI input, to route MIDI controller data from my 3 pedals and XS1 & XS2, to soft synths in my computer. That same data went also to the Axe Ultra and I could use the same pedals for controllers in the Axe as well. While the MFC101 and Axe II are working just fine with one another and AXE EDIT I now have controller issues.
So today I put the AxII in the rack and have tried all the setting combinations I can think of. MIDI adaptor is ON and MIDI THRU is ON.
All I can get in regards to MIDI messages out of the USB connected AXE II is "invalid messages" - even though all the pedal and switch assignments are the same as before.
How can I get the Axe II to simply echo unadulterated CC messages out to a specified MIDI port?
I tried it using AXE EDIT with MIDI Merge set to a port and did get messages - but they incorrect and were strange and seemed random - like "channel pressure", "program change", Tune Request" etc. This makes no sense to me. I get either no messages at all or junk.
I'm not an amateur at using advanced MIDI setups but this has me stumped.
If I have to I can go back to using the discrete MIDI output again to the MIDI router - but that would be going backwards for me.
I am trouble shooting using MIDI Monitor.
I had a terrific MIDI setup with my the MFC101 and the Ultra - I used a MIDI interface between the MFC 101 and the Axe MIDI input, to route MIDI controller data from my 3 pedals and XS1 & XS2, to soft synths in my computer. That same data went also to the Axe Ultra and I could use the same pedals for controllers in the Axe as well. While the MFC101 and Axe II are working just fine with one another and AXE EDIT I now have controller issues.
So today I put the AxII in the rack and have tried all the setting combinations I can think of. MIDI adaptor is ON and MIDI THRU is ON.
All I can get in regards to MIDI messages out of the USB connected AXE II is "invalid messages" - even though all the pedal and switch assignments are the same as before.
How can I get the Axe II to simply echo unadulterated CC messages out to a specified MIDI port?
I tried it using AXE EDIT with MIDI Merge set to a port and did get messages - but they incorrect and were strange and seemed random - like "channel pressure", "program change", Tune Request" etc. This makes no sense to me. I get either no messages at all or junk.
I'm not an amateur at using advanced MIDI setups but this has me stumped.
If I have to I can go back to using the discrete MIDI output again to the MIDI router - but that would be going backwards for me.