OKAY... lets see if this works...
It should get you close...once you get the hang of it...it's easier than it sounds.
at least others will see what you are doing and can probably help correct where I went wrong
...also worth mentioning...this is all kinda untested...It's getting late here and I am beat
Reset the pedal to a default…
This is the one I use… hold down the 1 and 6 pedal while powering up the board.(YOU WILL LOSE ANYTHING YOU HAVE DONE SO FAR)
Once done you need to make sure you have direct select disabled and set up the Midi channel.
To do this power off, then power on holding the “down” button.
When it is up and the green direct select light is on…make sure the red light on the 10 pedal is off.
If not press the 10 to turn it off.
Press up…the midi light flashes…
Press 6 and press up
Assign a midi channel…I used 1
Press up 3 times to get back to midi light
Press 7 press up
Assign it the same midi channel (1)
Press up 2 times
Hold the down pedal until it exits setup
Now in bank 00
Press pedal 5
Now
We will tell it to switch patches on the axefx.
>>*Hold the down button to enter setup
Press up 1 times
If you want your expression pedals active press and hold the 8 and 9 pedals to make them light(NOT FLASHING)…may be lit already…
Make sure button 5(only on bottom row) is lit up if not press 1 time
Press up
Press and hold pedal 1 till it is steady on…may be already…then press 1 time to make flash.
Press up
Input the patch # you want it to call up on the axefx…not sure how high it can go…just for ease sakes keep it under 99…you can resave your patches on the axefx to a lower number if need be.
Anyway for now input #33.
Press up
Press down and hold to exit
Now it should change the patch on the axefx to 33
Now press pedal 4 and go back up to the
>>* this time make sure button 4 is the on one lit
Do everything the same only use # 34
This will make the axefx change to 34 when pedal 2 is pressed.
Program all patch changes this way
Now for the stompbox thing.
Press up to bank 01
Press button 1
**Press and hold down to enter setup
Press up
Make sure button 1 is the only one lit
Press up
Make button 6 flash
Press up
Give a controller # (21 will do)
Press up
Give it 00 for value 1
Press up
Give it 127 for value 2
Press up
Dress and hold down to exit setup
Press button 2 and do the same thing** making sure button2 is the only one lit
Then to button 3 and so on…
Now in axefx
Hit the I/O button
Go to ctrl page
Scroll down the the effect you want to control
Hit enter to “learn” press the button on the fcb you want to use and it should show up with the # you assigned to that button.