The high Speaker Impedance value combined with increased Transformer Match and the unique topology of the amp is causing convergence issues. The plate current isn't converging in the allotted time.My Axe-FX is farting after the update. I attach a sound sample and a farting preset that was working fine before the update
I have reverted the firmware to 9.01, and the fart is gone
Just tried your preset here and no farting, and I'm not a fart-shy person usually
Also, the output level of this preset is very low on my axe, it lies at -20dB on the vu meter
See post immediately preceding yours.Thank you for savoring the flatulent preset.
I've just noticed that it only happens when playing certain notes. e.g: B on the 3rd string. And it doesn't happen with the bridge pickup, only with the neckpickup. That means that the babble is only released at certain frequencies, and only when there is low-end harmonic contents.
I have recorded both the raw signal and the flatulent signal at the DAW.
I attach a zip with the following files:
- Friedman FART.wav ~ Axe-FX Output with flatulence
- Friedman REAMP.wav ~ The RAW signal of my guitar, for reamping
- Friedman Fart.syx ~ The Durian preset
It seems Cliff found what's causing the issue, see the post above yoursThank you for savoring the flatulent preset.
I've just noticed that it only happens when playing certain notes. e.g: B on the 3rd string. And it doesn't happen with the bridge pickup, only with the neckpickup. That means that the babble is only released at certain frequencies, and only when there is low-end harmonic contents.
I have recorded both the raw signal and the flatulent signal at the DAW.
I attach a zip with the following files:
- Friedman FART.wav ~ Axe-FX Output with flatulence
- Friedman REAMP.wav ~ The RAW signal of my guitar, for reamping
- Friedman Fart.syx ~ The Durian preset
Oh yes. Thank youSee post immediately preceding yours.
Hey @FractalAudio. I found a bug that freezes the Axe every time and is repeatable. See attached preset. I created two scenes to show this. Basically, inside a single preset I was swapping between a JC120 and JTM45, both with input boost engaged, and I believe there's some Gain Enhance set too in one or both. If you start on the JTM (scene 2 in this preset), and change to the JC120, while playing, it overloads the Axe, and all inputs light up, killing all sound, and a reboot is required. I noticed you must play while swapping to reproduce. I have no idea if it was this way prior to this latest firmware. I was just trying to rebuild one of my all-in-one goto presets when I found a great clean/dirty amp pairing for my LP in these two, and was playing while swapping, and boom my Matrix pops with the overload and the Axe output lights stick full on. I also recreated the preset with no out before the cab for the heck of it (just FRFR) and it still happens. I have a FC Layout Page called "Amp Select" with 4 buttons for 4 amp channels, with also control switches for boost and such on the page, and then of course an easy exit back to the preset performance layout. I often use that layout for dialing in amps for the preset. I was just playing and swapping, and this bug rears it's head every time on this pairing. Anyway.. hope this helps.