The block library loads the entire block which means all channels as they were saved. If you save a block while on Channel A, then change to Channel B and load the block, you are still loading the entire block, so Channel A would go to Channel A.Is anyone else having issues saving blocks/channels?
Last night I was making a Mesa preset. Put a MKIV amp and a Framus/Recto Cab in Scene 1/Channel A. I saved the cab as a block as I wanted to use those two speakers elsewhere. I switched to Scene 3/Channel B and when I went to load the saved cab block, it would not load the one I saved, just kept the same cabs that were already in Channel B. I manually selected the cabs I wanted and went to load a IIC+ amp into Scene 3/Channel B, but it loaded it into both Channel A and Channel B, removing the MKIV I put in earlier.
At that point, I gave up as it was getting late and I spent about an hour tweaking that MKIV only to have all the settings wiped out (When it loaded the MKIV in Channel A, it went all back to stock settings).
I dunno if it was just late and I was doing something wrong, but I don’t recall any shenanigans like that happening previously.
It is not a “channel library” so that’s why Channel B didn’t change.