I knew I was forgetting something:I can not find Motor drive in amp block, Motor drive in cab block shows 0, when I reset current drive on the cab, Motor drive shows 6.7
Please advise.
Thanks
I knew I was forgetting something:
Cheatsheet Addendum:
The AMP BLOCK motor drive can ONLY be set from the front panel until Axe-Edit is updated.
A good policy is to correct the level in the block that's messing up your level.I've started using the Optical Comp after the Cab and the volume of the presets drops about 6 or more dB. Do I correct the volume with the "Level" in the Comp block or should I increase the Level in the Amp block, which means I run Level than on about "0" ?
How do I know Motor drive is being used either by amp block or cab block?
how should I adjust the Motor drive on either one?
Thanks
The situation with motor drive options in both the AMP block and the CAB block is just crying out for a table!
View attachment 38912
Look at the Motor Drive parameter in each block. If it's not set to zero, it's being used.How do I know Motor drive is being used either by amp block or cab block?
With the Motor Drive parameter.how should I adjust the Motor drive on either one?