Do you guys reset the amps? I had the impression Axe Fx users don´t...?
Or am I wrong?
What you do is:in which way is it possibile to reset the amps?
"refresh after new firmware" in the settings menu?
What you do is:
1. Refresh after firmware
2. Soft reset the amp of every preset you want to use. That is: Go to the amp block, select another amp, then reselect the amp that was initially there. Done.
But keep in mind Cliff said resetting the amps was not necessary with FW 8 in the AxeFX II thread. I assume its the same for the AX8.
did the release notes say it's necessary?Hold on a minute.... I was just looking at the AxeFX 8.0 thread again to see if I could find the post. It was a user, not Cliff that said a reset is not necessary.
https://forum.fractalaudio.com/thre...0-firmware-release.126824/page-2#post-1508921
Have fun at the gig. Where are you tonight?I got a gig tonight or I would update for sure. Loving 8.0 on my Axe-FX II.
Well we might not say it out loud, but we doEven in CPH, DK?
Sage and Sand. Out by Luke AFB.Have fun at the gig. Where are you tonight?
on user feedback the Amp block Speaker Drive now defaults to zero.
But keep in mind Cliff said resetting the amps was not necessary with FW 8 in the AxeFX II thread. I assume its the same for the AX8.
FWIW my existing AX8 presets all had the Speaker Drive at the former default so I reselected all of my amps anyway to pick up the new default value (I didn't completely reset the block; I already did that when I went from v6 -> v7).
I could have just zero'd the Speaker Drive on all of my presets but I like a select/reselect of the amp block since it resets my EQ/ Bright Cap, etc. settings which I tweak at times. I like those types of parameters reset to the amps defaults.
https://wiki.fractalaudio.com/axefx...Re-select_or_reset:_recall_Amp_block_defaults...what's the difference between an amp block reset and an amp reselect?