bread
Power User
I'm not sure if this is a bug or not (I suspect it is).
If you put a Multi Tap block (or stereo delay block) in parallel with the signal chain and bypass it, when you look at the block through the "Meters" page on the Axe FX3 only one channel has signal going through it. When the block is activated, both channels have signal passing through it.
I have my parallel blocks bypass mode set to "Mute In" so I don't think this would be a problem, but where Mute FX is used it could be.
Just checking in case its a problem.
If you put a Multi Tap block (or stereo delay block) in parallel with the signal chain and bypass it, when you look at the block through the "Meters" page on the Axe FX3 only one channel has signal going through it. When the block is activated, both channels have signal passing through it.
I have my parallel blocks bypass mode set to "Mute In" so I don't think this would be a problem, but where Mute FX is used it could be.
Just checking in case its a problem.