Joe Bfstplk
Legend!
Woof! The new 10.00b sounds and feels great! Also loving the ability to choose all flats for the tuner.
What guitar and pickups?One other question - I just can't get a clean sound out of the Jubilee, can't remember if this was better before - but even with input trim on 0.1 and the input gain right down I'm getting breakup (quite a lot)
What guitar and pickups?
Fixed exported Tone Matches may, in rare cases, not sound the same as the Tone Match.
Switching between scenes in a preset and had a "pop" and input meter on the Axe-FX III and my DAW went to red and stayed there.
No more output after that.
Noticed the same behavior when switching between amp channels.
Youtube would also not play after that unless I unselect Axe-FX III in my aggregate device.
The only way to fix was to reboot the computer.
Here's the preset.
Are you lowering input drive as well? It cleans up nice for me with lower drive setting and my PAFish PRS.Terry Morgan Les Paul replica with genuine PAFs - so not high output
Come to think of it, my issue occurred with the JC120 as well.So it's the JC120 one more time....
Are you lowering input drive as well? It cleans up nice for me with lower drive setting and my PAFish PRS.
Are you lowering input drive as well? It cleans up nice for me with lower drive setting and my PAFish PRS.
Come to think of it, my issue occurred with the JC120 as well.
I took the JC120 out of my preset, and it's working here as well.Took the JC120 out and no issues.
That’s a awesome feature thanks Cliff10.0
Added Downtune control to Tuner. The Downtune control allows for simplified tuning when tuning down one to four semitones. The Tuner display will read the “natural” name of the note, i.e. if tuning down one semitone an Eb will read E. In addition any blocks that utilize pitch information will also be transposed accordingly.
Added Display Mode control to Tuner. This control allows selecting between all flats, all sharps or a mixture of sharps/flats for the displayed note name.
New power amp modeling algorithm. This algorithm improves the plate impedance accuracy substantially. This yields tighter bass and “chimier” highs.
Due to the changes in the power amp modeling algorithm the Power Tube Hardness parameter now behaves differently. Selecting a Power Tube Type loads the “knee voltage” for the power tubes and this voltage can be adjusted up or down using Power Tube Hardness. Higher values yield a lower knee voltage and more abrupt clipping and vice-versa. Existing presets will have Power Tube Hardness reset to 5.0 upon recall.
Added KT77 power tube type.
Fixed exported Tone Matches may, in rare cases, not sound the same as the Tone Match.
Hmm. Guess it makes sense the JC120 is causing issues -- the one amp that doesn't have tubes. Likely some special bits in there to account for that fact that aren't working with the tube power amp updates?