Can you take a photo of the screen or a video during the bootup? The new build has a quick diagnostics display and will show us where it's hanging.Still no good here.
Can you take a photo of the screen or a video during the bootup? The new build has a quick diagnostics display and will show us where it's hanging.Still no good here.
Read the edit on my previous post.. that’s exactly what it was.. it’s all good now. Thank you for your help.Can you take a photo of the screen or a video during the bootup? The new build has a quick diagnostics display and will show us where it's hanging.
Try downloading with a different browser. I just went through the same thing, my browser wasn’t downloading from the site, just giving me a cashed version on my hddNo luck here either. I just downloaded using the link in the OP and performed the firmware update. Now when I power on the unit I get an all white screen that flashes for less than a second then a black screen. Nothing else. Output and other LEDs do their usual flashing pattern.
I'll try to reflash again.
maybe try renaming the file on your end? Someone else just ran into the same issue.Can you take a photo of the screen or a video during the bootup? The new build has a quick diagnostics display and will show us where it's hanging.
Probably won't help in my case as I didn't download the file from the previous thread.Try downloading with a different browser. I just went through the same thing, my browser wasn’t downloading from the site, just giving me a cashed version on my hdd
Ohh.. gotcha.. well the SYX timestamp I got to work was 7:04. Not 4:52Probably won't help in my case as I didn't download the file from the previous thread.
Booted into Emergency Utility and am now uploading.
I didn't think to check the timestamp on the previous download before I deleted it. After extraction this one says 7:04. I don't know how I could have downloaded the wrong file. In any case firmware is now uploading.Ohh.. gotcha.. well the SYX timestamp I got to work was 7:04. Not 4:52
I think there was a cached version floating around the web. I changed the name in the OP.Third try was the charm. Got the diagnostics stuff then the splash screen and am now up and running!
read all of the release notes so you know what has changed. it's substantial.Ha, first update since getting the III...went perfectly from 1.09 ---> 2.05
Thank you!!!
read all of the release notes so you know what has changed. it's substantial.
cached...cashed
Axe-Fx III Firmware Release Notes
2.05
Corrected the VU meters in the Output block to compensate for the “unity gain” nature of Outputs 3 and 4. Note that the Output block meters are BEFORE the Level controls (pre-fader) on the front panel and are therefore unaffected by the Level controls. The meters indicate the internal signal level relative to full-scale (dBFS).