Can someone please explain when and why blocks need to be reset after loading up a new firmware revision. I am really quite confused about that whole thing.
When I load up a new firmware revision, do I have to go into every single preset and change the amp type to something different and then back again to the original? What exactly does that accomplish?
Is it only the amps that need to be reset? Why not the other blocks?
Do I have to do that for just the presets that I've created or do the factory presets need resetting too?
Is there a quick way in axe edit to do this ... for example, does ctrl-i on the amp block accomplish this or do I actually have to toggle the amp type?
If I dump my banks to disk and then reinstall them after a firmware revision, would that take care of the resetting problem?
Do all firmware revisions require this - e.g do 12.0 and 12.01 both require resetting?
Thanks for any light you can shed on this ...
When I load up a new firmware revision, do I have to go into every single preset and change the amp type to something different and then back again to the original? What exactly does that accomplish?
Is it only the amps that need to be reset? Why not the other blocks?
Do I have to do that for just the presets that I've created or do the factory presets need resetting too?
Is there a quick way in axe edit to do this ... for example, does ctrl-i on the amp block accomplish this or do I actually have to toggle the amp type?
If I dump my banks to disk and then reinstall them after a firmware revision, would that take care of the resetting problem?
Do all firmware revisions require this - e.g do 12.0 and 12.01 both require resetting?
Thanks for any light you can shed on this ...