Sully0556
Inspired
Ok friends, I need some input. I recently purchased a new guitar for a backup unit on stage and it's a little brighter than my main guitar. I run a different preset for every song so it's not just an easy EQ tweak in the middle of the set and I'm not going to go in and mess with the global EQ on the unit between songs. I'm going to throw a MXR 8-band EQ onto my Temple board and run it between my wireless and my FM9 input, that way I can tweak the 4K a bit as needed and just activate the EQ when I grab the second guitar. Does this sound like an acceptable solution? I have no set songs for the second guitar so it may be played on any song.
Also... I'm getting a lot of noise across all presets and I've found that if I unplug my cable from input 1 and plug it back in the noise disappears but sometimes comes back after a while and I have to unplug it again. I've tried spraying gunk-out into the input and also on the cable and even used a bit of steel wool on the cable end to make sure it's clean. I run the wireless for gigs and band practices but run a standard guitar cable at home so I'm swapping that cable at least once a week. Any suggestions?
Thanks in advance.
Also... I'm getting a lot of noise across all presets and I've found that if I unplug my cable from input 1 and plug it back in the noise disappears but sometimes comes back after a while and I have to unplug it again. I've tried spraying gunk-out into the input and also on the cable and even used a bit of steel wool on the cable end to make sure it's clean. I run the wireless for gigs and band practices but run a standard guitar cable at home so I'm swapping that cable at least once a week. Any suggestions?
Thanks in advance.