NoDumb question, hopefully.
Is there a way to copy an amp channel from one preset to another using FracTool? How about without it, ideally on the front panel?
Use FracPad or AxeEdit channel clipboard
NoDumb question, hopefully.
Is there a way to copy an amp channel from one preset to another using FracTool? How about without it, ideally on the front panel?
Thanks for the steer, didn't know about the channel clipboard, relative Fractal newb here.No
Use FracPad or AxeEdit channel clipboard
NoAfter browsing this thread I suspect the answer is "no" but will ask... Can FracTool convert down from an AxeFX III patch to an AxeFX II patch ?
No
But it can display an AxeFx III preset offline, hence allowing you to try to copy it manually. Which will of course not produce the same sound,because of different firmwares etc...
Do tell... Is there a tool I'm not thinking of?I know how to see the presets that use each IR.
This function is in FracTool, under the name "cab list"Do tell... Is there a tool I'm not thinking of?
Ok cool!This function is in FracTool, under the name "cab list"
Took me a minute to figure out how to use it tbh. It comes up blank, you have to click refresh to tell it to get the data from your Axe, which takes a fair while; seems like it reads each preset one by one over midi.This function is in FracTool, under the name "cab list"
Yes fractool is a tool for power users, can't be too simpleTook me a minute to figure out how to use it tbh. It comes up blank, you have to click refresh to tell it to get the data from your Axe, which takes a fair while; seems like it reads each preset one by one over midi.
Well, if it doesn't have data, it could show a Get Data buttonYes fractool is a tool for power users, can't be too simple
That is refreshWell, if it doesn't have data, it could show a Get Data button
Not trying to be a pain, just trying to help, but that button could be more prominent, like big and right in the middle where the empty data grid is now, so you really couldn't miss it.That is refresh
A lot could be done but it's a free tool and time is limited...Not trying to be a pain, just trying to help, but that button could be more prominent, like big and right in the middle where the empty data grid is now, so you really couldn't miss it.
Understood.A lot could be done but it's a free tool and time is limited...
Use latest axefx3 firmware or do the conversion with your axefx3 connected and droping old files on axe-fx-3 icon in FracToolHello, I converted syx file for Axe II into Axe III, but nothing is shown when I import the converted file into my Axe III.
What was wrong?
I attached both files, before conversion and after conversion.
Thx a lot and I could make it, but the preset seems to be very noisy and very far from the sound I heard from the post someone had done in another forum.Use latest axefx3 firmware or do the conversion with your axefx3 connected and droping old files on axe-fx-3 icon in FracTool
If the source firmware is not Quantum 2 and the destination firmware is not Quantum 2, of course, think about it : AxeFx 3 firmware evolved a lot from Quantum 2 to 12.07 where it's at now...Thx a lot and I could make it, but the preset seems to be very noisy and very far from the sound I heard from the post someone had done in another forum.
Is that the correct effect of the conversion?