Yes i know roads are not very good in your countryAh, the roadmap... If you saw mine
Thanks again for this great tool !
Yes, you had to select blk extension in the file selectorgot it working. Thank you so much.
Supported only for gen2Al, I just was trying out FracTool 2.97 and when selecting Amps Compare tab the program vaporizes. Is there something I'm doing wrong? I have little experience with it
specs are in my signature
Short demo of the batch setter
Yes, it's something to allow in future versionsThanks for the demo
To set just a Y setting value, do you need to set both X and Y to the new Y value, then reset the X value? That seems a bit weird, did I misunderstand your video?
First thing on my todo list after fracpad III releaseLooking forward for the batch setter for III.
No it's not possibleAl
Thanks for a great piece of software.
The batch setter saves a load of time for block changes across presets. However, is it possible to batch set the default scene that a preset will open on? As it is not a block, this does not appear as a parameter that can be saved across presets unless I'm looking in the wrong place.
I know I can set the AX8 global parameter to set a default scene but this still requires each preset scene to be set to global so, changing this over 50 or so presets it is tedious. Any advice is appreciated.
"Quibble"...am i missing something?
i have this simple ax8 patch.i convert it to fx8 and it doesn't have the blocks connected.(its been a while i forget the name of them)
so it doesn't work on the fx8.so i go and use "save block" for each effect and save to a blk file.put them in the appropriate folders and it doesn't read them. it seems like i should be able to load a ax8 file and save the individual effects to my blocks.