• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

FM3 Firmware Version 3.01

BryantP

Administrator
Moderator
FM3 Firmware Version 3.01 is now available for download:
https://www.fractalaudio.com/downloads/firmware-presets/fm3/3p0/fm3_dsp_rel_3p01.zip

Release Notes:
• Fixed amp block’s Cathode Follower Compression value not loading correctly for patches saved under firmware prior to version 2.0.
• Added “59 Bassguy Jump” Amp type.
• Fixed Scales menu in Global Settings not synchronizing with FM3-Edit.
• Fixed audio artifact when changing channels and viewing the Tone page on the amp block in some circumstances.
 

teddis

Fractal Fanatic
So i am not clear....where all effected amps preset compression values overwritten with 3.0 to the 69.9 ?

If , we had a pre 3.0 back up....should that be loaded...then to 3.01 ?
 

BryantP

Administrator
Moderator
So i am not clear....where all effected amps preset compression values overwritten with 3.0 to the 69.9 ?

If , we had a pre 3.0 back up....should that be loaded...then to 3.01 ?
If you saved a preset that was previously saved under 1.06 or earlier, the Cathode Compression value would have been overwritten with 69.9. You can restore before or after you go to 3.01 or you can just set that value as appropriate for your uses and save the preset.
 

teddis

Fractal Fanatic
So we can use the Fractal bot to send 2.0, then load 2.0 back up, then load 3.01

This will leave these in the correct state , right ?
 
Top Bottom