FM3 Firmware Version 3.01

BryantP

Administrator
Moderator
FM3 Firmware Version 3.01 is now available for download:
https://www.fractalaudio.com/downloads/firmware-presets/fm3/3p0/fm3_dsp_rel_3p01.zip

Release Notes:
• Fixed amp block’s Cathode Follower Compression value not loading correctly for patches saved under firmware prior to version 2.0.
• Added “59 Bassguy Jump” Amp type.
• Fixed Scales menu in Global Settings not synchronizing with FM3-Edit.
• Fixed audio artifact when changing channels and viewing the Tone page on the amp block in some circumstances.
 
So i am not clear....where all effected amps preset compression values overwritten with 3.0 to the 69.9 ?

If , we had a pre 3.0 back up....should that be loaded...then to 3.01 ?
 
So i am not clear....where all effected amps preset compression values overwritten with 3.0 to the 69.9 ?

If , we had a pre 3.0 back up....should that be loaded...then to 3.01 ?
If you saved a preset that was previously saved under 1.06 or earlier, the Cathode Compression value would have been overwritten with 69.9. You can restore before or after you go to 3.01 or you can just set that value as appropriate for your uses and save the preset.
 
So we can use the Fractal bot to send 2.0, then load 2.0 back up, then load 3.01

This will leave these in the correct state , right ?
 
Back
Top Bottom