JRod4928
Power User
I've set up presets before to eliminate clicking but it ends up being too round and not clear. And other presets that are clear but has noise from fret clicking/finger sliding/string slapping. Any tips?
Here's what I followed so far. Copied and pasted from a "guest user" named Lionheart.
In this order on the grid line:
1) Amp block using the SV Bass. (Or Blackglass drive)
2) Filter block set to high-pass around 50Hz.
3) Filter block set to low-pass around 4kHz+.
4) Compressor block in Studio mode. Fast release, medium attack, 2:1 ratio.
5) Another Compressor block in Studio mode. Fast release, fast attack 4:1 ratio.
6) PEQ Block. Notch out somewhere between 60 to 80Hz to let the your drummer's kick drum cut through. Keep an eye on the 160 to 200Hz, 250 to 500Hz, and 2kHz to 4kHz ranges. Look at possibly subduing these ranges with your EQ. Most of those ranges contribute to muddiness and then the higher range can get harsh with fret noise.
Here's what I followed so far. Copied and pasted from a "guest user" named Lionheart.
In this order on the grid line:
1) Amp block using the SV Bass. (Or Blackglass drive)
2) Filter block set to high-pass around 50Hz.
3) Filter block set to low-pass around 4kHz+.
4) Compressor block in Studio mode. Fast release, medium attack, 2:1 ratio.
5) Another Compressor block in Studio mode. Fast release, fast attack 4:1 ratio.
6) PEQ Block. Notch out somewhere between 60 to 80Hz to let the your drummer's kick drum cut through. Keep an eye on the 160 to 200Hz, 250 to 500Hz, and 2kHz to 4kHz ranges. Look at possibly subduing these ranges with your EQ. Most of those ranges contribute to muddiness and then the higher range can get harsh with fret noise.
Last edited: