That's also my experience on my amp, but I don't have a schematic to guarantee it's completely identical.I tested this on my Sig:X tonight and I can’t hear or feel any difference engaging / disengaging the boost function when the gain II knob is turned to minimum.
That's also my experience on my amp, but I don't have a schematic to guarantee it's completely identical.
And that's probably why it'll never be modelled too. Making a model without a schematic is intensive enough. With all the switching and functionality in the circuit it's got to be 10x worse.
Side not, heck of an amp isn't it?
I own an Axe III. I know, I sure do.I am sure Cliff appreciates people complaining about the FM3 being behind in every release thread.
And Here is the Custom Audio 3 cooked with love
(Dunlop dimebag as wah)
I thought the Rectos were pretty damn accurate. I wonder what the change was.
One of my favorite flat earthers...This photo is of Stephan Carpenter’s D120 settings. Fryette just posted it on their social media accounts
View attachment 133757
View attachment 133758
I just updated to 24.04 about an hour ago and everything works fine. Maybe try reloading 24.04.Hi, I just updated with the Fractal Bot from 24.03 to 24.04. After the update, output 1 no longer works properly. I only get a signal of 20% on output 1. Everything is way too quiet. The Output LED shows only one light when the Output 1 Level is fully turned up. With the other Ouput2 and 3 the problem is not. Does anyone have any advice? Can and should I go back to 24.03? But how? Or is the Output1 defective?
Here is the link to 24.03 if you can't get .04 to work right away.Hi, I just updated with the Fractal Bot from 24.03 to 24.04. After the update, output 1 no longer works properly. I only get a signal of 20% on output 1. Everything is way too quiet. The Output LED shows only one light when the Output 1 Level is fully turned up. With the other Ouput2 and 3 the problem is not. Does anyone have any advice? Can and should I go back to 24.03? But how? Or is the Output1 defective?
Check to see if Output 1 had been changed to -10dBu instead of +4dBu.Hi, I just updated with the Fractal Bot from 24.03 to 24.04. After the update, output 1 no longer works properly. I only get a signal of 20% on output 1. Everything is way too quiet. The Output LED shows only one light when the Output 1 Level is fully turned up. With the other Ouput2 and 3 the problem is not. Does anyone have any advice? Can and should I go back to 24.03? But how? Or is the Output1 defective?
That‘s not the problem.Check to see if Output 1 had been changed to -10dBu instead of +4dBu.
Is this on one preset? Have you switched to the layout page which shows the block levels? That will show if there’s a block causing this.That‘s not the problem.