yek
Contact Fractal for your Custom Title
Agreed!! It is kind of my go to Marsha, Marsha, Marsha now. #34 rocks!
Yes, the unthinkable happened. The 34 has replaced my BE as my favorite dirt amp.
Agreed!! It is kind of my go to Marsha, Marsha, Marsha now. #34 rocks!
Me three!Me too!
+1000Really glad that my Q7 presets are pretty much translating with no adjustment on this FW. Redials are brutal/time sinks.
New cable didn't make a difference. I'm guessing it's the software. Oh well, I'll just enjoy fw while waiting
Yeah. I always wondered if it had been a little lower in the drive department than what MR VH had been working with. Its very hard to know I'm sure, but its very cool that Cliff did this cuz attempts at matching this amp have always been a special case for me in terms of interest, and wished for musical journeys. I look forward to spending an extra amount of time with her, without pissing any other amps or women off of course.What went wrong with the Brit Brown? I cannot be bothered to roll back and test it, but it's a helluva rocker now!
#34 is Bogfish strato in my XLYes, the unthinkable happened. The 34 has replaced my BE as my favorite dirt amp.
#34 is Bogfish strato in my XL
I'm a stupid, sorry, thanks!!Not preset or amp number in the list. Model name...
http://wiki.fractalaudio.com/axefx2..._Marshall_JCM_800_with_.2334_modifications.29
The 5F1 Tweed EC does not show up with the EC in the title??, Is there something I'm missing? I'm using an AxeFX 2 MkII8.00
Improved amp modeling. Improves clarity and sounds more “open” especially for non-MV amp models or when the MV is turned up.
The bias excursion values for most amp models have been updated based on new measurement techniques. Existing presets will automatically be updated to the new values.
Based on user feedback the Amp block Speaker Drive now defaults to zero.
Cab block Delay parameters now have 0.001 ms resolution.
Increased gain of “Brit Brown” model by 12 dB.
Added “5F1 Tweed EC” based on a Fender Eric Clapton Vibro-Champ.
Fixed “quantization” noise when Amp block Transformer Drive parameter is set to its minimum value and a lot of gain is applied after the block. This specifically addresses the “Tube Pre” model as the default Transformer Drive is at the minimum.
Fixed Amp block Preamp Hardness parameter not “sticking”.
Fixed incorrect Modifier mapping in Advanced page of Amp block.
The 5F1 Tweed EC does not show up with the EC in the title??, Is there something I'm missing? I'm using an AxeFX 2 MkII
Nope did that still not showing??In Axe-Edit? Refresh the definitions (Settings >> Refresh).
Just fixed itself, restarted AXe EDit, all good now thx Yek!!!Nope did that still not showing??