Hi Chris. thanks again for your attention. The problem isn-t only with preset 009 and switch number 4. The video show that, but the malfunction don't correspond to a concrete preset or switch.I know it's a factory preset, but switch to Preset 009. What is the CPU usage on that one? Press the Utility button on the front panel and page right till you see the CPU meter.
GotMetalBoy, thanks for your answer.What Firmware do you have installed on your Axe-Fx II ?
What kind of computer and OS are you using to run FractalBot?
What Version of FractalBot & Axe-Edit are you using?
What MIDI Interface are you using with your computer or are you using the Axe-Fx II as your MIDI Interface?
Backup your Axe-Fx II & MFC-101 w/ FractalBot then Reset your Axe-Fx II & MFC-101
To reset the MFC-101:
Power Off Axe-Fx II
Disconnect all cables
NOTE: When Resetting or Updating Firmware, Only use the Power Adapter to power the MFC-101 DO NOT use the Network cable to power it
Hold down IA 11 while powering on and then hit IA 14
I repeat the above steps twice just to make sure everything is good
Here's my post about how I reset my Axe-Fx II:
Thanks for the attention, yek.If you changed the offset on the Axe-Fx, you should change both offset values on the MFC too: Axe-Fx offset and MFC Display offset.
Also, change Bank Style to None to speed up scrolling up/down and prevent hiccups.
LOL... thanks for the explanation, shashaI wonder if the fact that the offset was mismatched and that it was ignoring redundant program changes didn't just create it's own little problem. I mean if it thinks that it's on preset 009 already, but it's really on 008 than telling it to go to 009 isn't going to happen. Then you tell it over and over again and it's just ignoring you because you told it to ignore redundant PC's. Then when it does finally take it's like "but I'm already on 008" and actually changes, but it appears that it is just staying the same.
I mean I could see where there could be some confusion in the communication between the two devices. It's basically the protocol I use at work....confusion, different page, frustration, nothing getting done.