ConnorGilks
Experienced
I've been using Axe-Edit 3 just fine since it came out until today. I opened up a patch on my AxeFX II and went to rename it. I change the name and hit enter and I wait while it processes. It comes back with an error message saying:
"Communication Failure: Axe-Edit was unable to complete the communication due to time-out."
I then can't click on the preset selection buttons or the preset name bar. I look at my AxeFX II and the patch name changed just fine though, and nothing seems to be wrong? I closed Axe-Edit and tried again and same error, but it also changed the name just fine. Just now I tried this same method a third time and right when opening Axe-Edit I get the same error message and it won't display my patch in Axe-Edit at all, despite it saying "Connected". Then if I scroll to another preset (on my AxeFX II, not in Axe-Edit) the whole patch layout shows up just fine in Axe-Edit and there's no more issue with it displaying. I'm using firmware 11.00.
EDIT: Just tried saving a few more names, two worked without issue, third one got the same error message.
"Communication Failure: Axe-Edit was unable to complete the communication due to time-out."
I then can't click on the preset selection buttons or the preset name bar. I look at my AxeFX II and the patch name changed just fine though, and nothing seems to be wrong? I closed Axe-Edit and tried again and same error, but it also changed the name just fine. Just now I tried this same method a third time and right when opening Axe-Edit I get the same error message and it won't display my patch in Axe-Edit at all, despite it saying "Connected". Then if I scroll to another preset (on my AxeFX II, not in Axe-Edit) the whole patch layout shows up just fine in Axe-Edit and there's no more issue with it displaying. I'm using firmware 11.00.
EDIT: Just tried saving a few more names, two worked without issue, third one got the same error message.
Last edited by a moderator: