Its a great preset.
Some constructive feedback which I hope helps you setting up future patches - There no point setting volume to the higher end - you are only setting overall AXEFX output level not any amp drive. All fractal presets are set to about 0db if you get too much higher you risk digital clipping in the unit.
Your extra volume is coming from:
1) the parallel cab blocks - setting both to -3db could fix that increase. But why are you using dual cab blocks with single IRs panned L/R - you can do that with one cab block - shown below. Saves CPU and makes aligning different IRs easier if needed.
View attachment 92622
2) The parallel Delay block. There is a 'better' way to do this. Set the bypass mode to "Mute In", set level to 0db, Mix to 100% (so you are only getting delay out of the block, then control delay volume using Input Gain - this prevents delay level changes when switching scenes or switching the delay block on/off. Leon Todd has a video covering this.
View attachment 92621
Hope this helps