Axe-Fx III Firmware 26.00 Release

[FractalAudio]

https://www.fractalaudio.com/downloads/firmware-presets/axe-fx-3/26p0/axefxiii_dsp_rel_26p00.zip

After installing the firmware you will then need to install the new DynaCab data pack (if you haven't done so already for the beta):
https://www.fractalaudio.com/downloads/firmware-presets/axe-fx-3/DynaCab/dyna_cabs_1p06.zip

Axe-Fx III Firmware Release Notes​

26.00

Improved phase inverter modeling in Amp block. This yields more “weight” and a more open tone when driving the virtual power amp hard (i.e. non-MV amps or MV turned up high).

Updated phase inverter parameters for most models based on new analysis tools.

Added “2x12 5153 Stealth” and “4x12 5153 Stealth” DynaCabs.

Fixed stand-in switch Tap functions not working in some cases.

Fixed pops/clicks can occur when changing Preamp Type in Cabinet block.

 

[Wayneii]

 

[Merlin]

Thanks a lot !!!

 

[bchulse]

Excellent, thank you!

 

[flitz]

Thank you Mr. C you are amazing always work in progress.

 

[is9582]

Excellent! Thank you Cliff and Team Fractal!

 

[sevenstring]

Awesome, Thank you!

 

[Chewie5150]

Hot diggity!!!! My Friday is set

 

[nojyeloot]

Such a gift. Thank you so much.

 

[Guitarzan69]

RANF Friday, can't wait to get home.

 

[deakle]

Thank you!

 

[TheRedDevil]

Fixed pops/clicks can occur when changing Preamp Type in Cabinet block.

Great, thank you FAS! No cat in the microwave warning needed

 

[hfam]

Woooo!! Firmware Friday rides again!!! Thanks Cliff, crew, all the beta testers!!

 

[rossipedia]

No FAS Stealth Blue?

 

[rsvette12]

Best one yet - thanks so much - sounds awesome

 

[Budda]

Happy friday all. Thanks Cliff and co!

 

[Matt payne]

thank's a lot for the firmware friday!! maybe a stupid question, but now when I open axe edit, I have the MIDI IN LED on in the front of the unit, on every presets. Did RANF, reboot the Axe. The LED go off when I quit axe edit.

 

[KyleHowdy]

Fixed pops/clicks can occur when changing Preamp Type in Cabinet block.

Absolutely blessed! King of the updates.

 

[Stratoblaster]

Improved phase inverter modeling in Amp block. This yields more “weight” and a more open tone when driving the virtual power amp hard (i.e. non-MV amps or MV turned up high).

Updated phase inverter parameters for most models based on new analysis tools.

Fantastic all around...the "PI" is such an important cog in the mechanism. Kudos for the final release...

 

[unix-guy]

thank's a lot for the firmware friday!! maybe a stupid question, but now when I open axe edit, I have the MIDI IN LED on in the front of the unit, on every presets. Did RANF, reboot the Axe. The LED go off when I quit axe edit.

That is and was always the case as far as I know.

The editor communicates over midi and it's in constant communication.