Lucky guy! Does she have a sister?I had a ton of fun with Dirty Shirley 2 last night!
Shirley Not!Lucky guy! Does she have a sister?
Thank you so much for the continual firmware updates Clif & Fractal Team!
I loaded 9.01 last night, but unfortunately at least 3/4 of my presets used the fair to moderate amounts of "Xformer Grind" (Transformer Grind)..
I LOVED that parameter, but sadly it went away with 9.00...
I often used it in place of Presence, Dynamic Presence, and high treble EQ.
I'm sure I can mimic it with "Dynamic Presence, Presence, and/or EQ, but nothing sounds quite the same (obviously)..
So my question to Cliff or any one else that might be able to help, is:
What parameter can I use in place of Xformer Grind?
Thanks!
I haven't played around with 'Grind' much but I tried (couple times) to brighten some tones using Xformer matching and got a bit more torqued and ballsy bright tone without hash or spitting - nice smooth but metallic timbre. I haven't tried the Xformer grind if that's a separate parameter.
When I brighten using Xformer matching I hear something that I haven't quite managed with just EQ., but it may just take more EQ blocks between stages to get the same effect. Anyway, if transformer grind does something special, maybe there can be a 'Xformer Grind' drive block in the future?
And stop calling me Shirley.Shirley Not!
Is there an actual IR loaded in the user cab slot that the preset is using?For some reason, when I switch to a preset or do a new patch that uses a user cabinet, the patch goes silent. Anyone else have this problem?
Tomorrow I'll upgrade all my patches to 9.01 from 8.02 (came from 6.03 without very much tweaking), is there any starting point to be made before tweaking ?
I noted there were variables in the AMP block
Spkr drv + Time const (200ms)
And in the CAB block :
Motor drv & Time const (200ms)
Working exclusively with FRFR I suppose I should start with putting the CAB block variables to zero (mtr drv & time const) and AMP block spr time constant to 100ms, then adjust spkr drive to taste.
Is that correct ?
Thks for any help.
It shows up in the cab slot with the name of the user cab. I even tried the factory patches and they worked fine until I change the factoryIs there an actual IR loaded in the user cab slot that the preset is using?