I checked again & the double verb seems to be OK but the Bludojai Lead (or any amp with the overdrive control) if it is in the Y position is not getting updated correctly. I tried on 2 different presets, 1 that was already there from previous firmwares & 1 I just made tonight.
1. Create preset with any amp other than the Bludojai in the X position, the Bludojai in the Y.
2.Save it so the X amp is the default amp, i.e. in scene 1.
3. Run the update current amp in the utility menu.
4. Now check the amps. The X amp will be fine but the Bludojai will have the overdrive set to 10. It should be 7.5.
5. If you set it up so the Y amp state is in scene 1 or is the amp that is currently active, the update works as it should. It is only if the Bludojai is in the Y position & the X amp is the active amp when you run the update.
I just checked the USA Pre Ld Grn model & it did the same thing as the Bludojai. Looks like any amp with the overdrive control that is in the Y position will have the overdrive set to 10 after you do the Update Amps Defaults command. If the X amp ALSO has the overdrive control, it works fine. It only seems if the X amp has the Input Trim & the Y amp has the Overdrive control is when the Y amps overdrive is set to 10.
Can Cliff or anyone else try this & see if it is happening on your Axe?