gdgross
Experienced
On the FASLINK xlr connector, I measure ~50ohms from pin 1 to case ground (chassis pin on power input terminal), and about 12V between pin 2 and pin 1. (Strangely, the USB and SPDIF connectors don't measure a short to chassis ground....perhaps there's a fully isolated power supply inside or something, but that's neither here nor there...)
I'd like to use this presumed 12V supply to run a couple of external MIDI switches. Thinking about either disaster area or midi expression, not sure yet. I can always regulate down if one of them can only accept a lower voltage.
Has anyone done this? I assume it's not authorized by FAS. Or, can anyone confirm the power pins on the FASLINK connector?
I'd like to use this presumed 12V supply to run a couple of external MIDI switches. Thinking about either disaster area or midi expression, not sure yet. I can always regulate down if one of them can only accept a lower voltage.
Has anyone done this? I assume it's not authorized by FAS. Or, can anyone confirm the power pins on the FASLINK connector?