Here are the Release Notes for older versions and Clarky I think you are correct that FW 3.02 was the last firmware that had anything for the MFC-101 Mark I & II. I think I installed FW 3.03 because it was the FW available when I updated from FW 3.00
RELEASE NOTES FOR OLDER VERSIONS
-------------------------------------------------
v3.05 Jun 19, 2014
-------------------------------------------------
WHAT’S NEW (Note: This covers fixes which were also released internally as 3.04)
1. Expanded Axe-Fx Transmit Program Change Map (“AxeFx Tx Map”) to support preset numbers
above 383 on the Axe-Fx II XL.
The TxMap allows you to map any MFC preset footswitch to any Axe-Fx II XL preset. (See the MFC-
101 manual, section 12.4.3 Axe-Fx Preset Transmit Map for more on this feature.)
a. If the model is not XL, any previous map entry greater than 383 will appear as 383 and
act as 383 (CC#0:2 and PC127).
b. When making changes to a pre-stored map entry greater than 383 while the model is not XL,
it only takes one button press to go from 383 to OFF.
Please remember that the MFC shows its own internal preset numbers and not those of the Axe-Fx
II. So mapping MFC preset 000 to Axe-Fx Preset 383 (“Bypass”) will show “X000 Bypass” in the MFC-
101 display.
IMPORTANT: When using TxMap for any Axe-Fx II, you must turn off “Total Sync” on the MFC-101.
Press EDIT, Press MIDI (#4), Page Right (#7) two times, and set TotalSync to “OFF”.
The MFC-101 will no longer automatically switch to presets selected from the Axe-Fx II Front
Panel, but TxMap will work as intended.
2. Fixed bug where the LED for the current SCENE wasn't turning on when exiting Looper
Control Mode.
3. Fixed a bug where “Revealed” IAs weren't being saved when using the Save Edits
footswitch.
4. Other minor changes and fixes.
-------------------------------------------------
v3.03 Apr 9, 2014
-------------------------------------------------
- Added Axe-Fx II XL support. Please be sure to select the correct model in the SETUP menu of the
MFC after updating.
- Added FASLINK support for the MFC-101 Mark III. Be sure to select the correct PORT in the MIDI
menu of the MFC after updating. Please also note that if you’re using an Axe-Fx II XL, you must
also select the desired MFC port (“EtherCON” or “FASLINK”) in the I/O:MIDI menu of the Axe-Fx II
XL.
* * *
-------------------------------------------------
v3.02
-------------------------------------------------
- Fixed bug in external switches where XS 3 and 4 weren't working correctly.
* * *
-------------------------------------------------
v3.01
-------------------------------------------------
- Solved an issue with Hold Tap for Tuner not working on switches except #1 and #17
- Solved an issue with BANK UP and BANK DOWN not repeating when the footswitch is held.
* * *
-------------------------------------------------
v3.00
-------------------------------------------------
First public release. The MFC-101 Mark III is not compatible with firmware releases prior to
version 3.00, (December 2014)
- 3.0 also adds the ability to assign SCENE 1/2 TOGGLE and VOL INCR, VOL DECR to Axe-Fx IA
switches.
* * *