I have an All Access and an Axe Fx II and I've connected both using a Rocktron 7-pin midi cable.
I went through the All Access manual and set up the all access so that buttons 1-5 are for changing presets and the rest of the buttons are for switching effects on and off within the presets, but that's as far as I can get.
Buttons 1-5 do change between presets 000-004 on the Axe, but when the All Access is connected the only sound coming out of the Axe is a very dull and low volume clean signal, so if I press button 1 preset 000 is called up like I want, but there is no sound from it.
Does anyone know what the problem might be? I have already performed a factory reset on the All Access but can do so again if need be to start over again.
I went through the All Access manual and set up the all access so that buttons 1-5 are for changing presets and the rest of the buttons are for switching effects on and off within the presets, but that's as far as I can get.
Buttons 1-5 do change between presets 000-004 on the Axe, but when the All Access is connected the only sound coming out of the Axe is a very dull and low volume clean signal, so if I press button 1 preset 000 is called up like I want, but there is no sound from it.
Does anyone know what the problem might be? I have already performed a factory reset on the All Access but can do so again if need be to start over again.
Last edited: