THIS:
Is there an image of the Rear panel? This looks absolutely stellar Axe Fx III !
So you want firmware updates that doesn’t change your tone? Then what’s the point.Question for anybody in the know on the new III
Will the firmware updates change your existing presets - Like it does currently with the existing/current models?
This is my biggest issue with the AXE FX2. The hundreds of hours fine tuning the finest detail to get the tone exactly where I want it.. Only for a new firmware to take away all my precious hours of perfecting...
Yes.Two amp blocks in high resolution?
I believe this was asked and the answer was no.I'm wondering if the new version of Axe Edit allow us to import and convert our Axe FX II presets to Axe FX III ?
I believe this was asked and the answer was no.
I know you were joking obviouslyTotally joking, geeze! Although I suppose some would think it's true with the some of the comments I've seen with other FAS product releases.
So you want firmware updates that doesn’t change your tone? Then what’s the point.
Hmm.....no problem here with fast and gapless presetchange........but the scenechange has a gap when using different x/y blocks.I don’t care about any of the fancy shit it may or may not do. All I want out of your ridiculesly powerful 4 dsp chips is gapless switching. I don’t care if it sounds better, I don’t care if there is so much I/O that I can route the signal through my ass, and back again, I want preset changes to be as quick as a scene change. Please and thank you.