4406cuda
Inspired
I just installed a couple of Celestion F12-X200 in Bogner 1x12 cabinets. The tones are a little fizzy and underwhelming. I am powering the cabs with a Matrix amp. I have the amp block set to FRFR and tried several cab blocks. I liked the LT 7 mix the best. I also used the preamp in the cab block to remove frequencies below 80 hz and above 10khz. I tried many amps and factory presets. I am playing at live band volume.
I had Celestion Alnico Creams in the Bogners and they sounded pretty good with the AXE III. However, I wanted to take advantage of the cab blocks and being able to hear what the audience hears if I send a signal to FOH. I was hoping the F12-X200 would give me the AITR feel and sound better than a traditional guitar cab setup.
Before I take the Celestions back out, is there any settings I should try to get rid of the fizzy sounds I hear.
If I get a EV PXM-12MP, will it sound much better than the Celestion F12’s?
Thank you in advance!
I had Celestion Alnico Creams in the Bogners and they sounded pretty good with the AXE III. However, I wanted to take advantage of the cab blocks and being able to hear what the audience hears if I send a signal to FOH. I was hoping the F12-X200 would give me the AITR feel and sound better than a traditional guitar cab setup.
Before I take the Celestions back out, is there any settings I should try to get rid of the fizzy sounds I hear.
If I get a EV PXM-12MP, will it sound much better than the Celestion F12’s?
Thank you in advance!