Question. Scott talked about the new feature in the Utility menu that allows you to balance the output levels of all your presets. I just updated to the latest firmware and my presets (factory and my own) are crackling pretty bad, particularly in the low end if I'm playing like a palm muted note or any chugging kind of riff, but it also does it just on a clean tone strum. I'm not clipping the output, not even close, never seen a hint of the red lights. I'm not high up on CPU and it is every guitar I own which is several. In this new Utility menu feature if I go down to -10 or -12 db it starts to clear up. I'm setting it on a strum like Scott suggested. Should I be trying to set them all to be hitting the 0 db line or is it normal to be at -12 or so? Crackles really bad at the 0 line, but I'm not clipping at all according to the front panel of the AxeFx. Does it have something to do with firmware 17 because this problem has never happened before until I updated? I did the update amps all presets feature but it didn't help. I'm mostly just a factory presets guy right now with just a few presets I've made myself. I use factory presets and I update firmware so I'm confused as to why it is crackling so bad all of a sudden. Any help would rock.