Flying Fingers
Member
I recently purchased a Mission EP-1 expression pedal with the return spring and am having an issue programming it. I am intending to use it as a WAH, for one. Everything is programmed, the pedal is calibrated, a WAH block is applied, the EXT 2 paramater is set and the pedal action is indicating on the grid when depressed. The ball does go up and down. The issue is the action of the pedal does not sweep. It is either on, or off, nothing in between. With the pedal off I can just barely depress it and it goes fully on. I changed the WAH block for a Classic Whammy to do 1 octive down and the same thing occured. It was either off, or all the way on, there was no inbetween. Any idea what I am missing?.
I have another pedal set to EXT 1 that is a volume pedal that works just fine. Don't know if there is a bad potimeter in the EXP-1, or if I am missing a setting on the AXE FX. Prior to this I was just going through a Cry Baby Wah.
Thanks,
Greg
I have another pedal set to EXT 1 that is a volume pedal that works just fine. Don't know if there is a bad potimeter in the EXP-1, or if I am missing a setting on the AXE FX. Prior to this I was just going through a Cry Baby Wah.
Thanks,
Greg