MIDI-OX over USB MIDI

[beagle]

I'm trying to configure MIDI-OX to update firmware via USB MIDI.
I was configure MIDI-OX with following step.

1.Choose menu [Options->MIDI Devices...]
2.On [MIDI Devices] panel,select [3)AXE-FX II MIDI Out] as [MIDI Inputs:]
3.Select [AXE-FX II MIDI In] as [MIDI Outputs:]

Immediately after that,MIDI-OX start to sending data automatically(continuously).
But anyway,I was hit [ENTER] key on AXE-FX II front panel then load firmware sysex file.
Data transfer has been started but few minutes later,MIDI-OX raise memory error.

Anyone know how to fix my problem?

Thx in advance.

 

[beagle]

Sorry,2nd trial was success!

But I'm curious what that automatic data transfer...

 

[shasha]

MIDI-OX will connect the input and output you select together automatically (there's a checkbox in the bottom left corner to disable that) and if you had MIDI THRU enabled on the AxeFXII it could have crreated a little feedback loop.

 

[beagle]

Thx shasha.

Then,I don't have to assign Input and Output manually while left corner checkbox checked,and also,configure Axe-FX II MIDI THRU disabled?

 

[s0c9]

Use the C6 Elektron MIDI filer.. simpler, easier to use and worx great. Can load up the file, prep eveything then hit send.

That said, why are you not using AxeEdit for firmware upgrades ???

 

[beagle]

Hi s0c9.

Thx for your suggestion.
I thought better to avoid use of non compatible version of Editor against latest firmware.

 

[javajunkie]

Hi s0c9.

Thx for your suggestion.
I thought better to avoid use of non compatible version of Editor against latest firmware.

Firmware updates are fine through an older version of the editor, works great.

 

[beagle]

Hi javajunkie.

Thx,then I will use editor
It is much easier.