Yes, assuming you're using both Out 1 & 2 to feed the backline and FOH, there are separate Output EQs for Out 1 & Out 2.
In Axe Edit click on output at the far right of the grid and then the Setup tab (I think)
You can also access these in the global menu on the unit, but I can't remember the buttons to press to get to it - many more knowledgable on here will know and will undoubtedly chip in!
The AX8 has 2 separate outputs with their own level controls and global EQs. There is no need for an FX Loop block in the grid for this option. You will have to set output 2 to "Echo output 1" in the I/O menu, in the Audio tab.What do you mean by Out 1 & Out 2? I'm using the main output section so L/R XLRs for FOH and L/R 1/4 outputs for backline.
The AX8 has 2 separate outputs with their own level controls and global EQs. There is no need for an FX Loop block in the grid for this option. You will have to set output 2 to "Echo output 1" in the I/O menu, in the Audio tab.
Then you will have to identical outputs. One for FOH and one for backline. Each with their own level control on the front panel, and their own global EQ.
Is your 'Back-line' FRFR (with Cab sims) or a standard guitar cab (without Cab sims)?
that's an old picture. you can see it's not even connected to anything, as the screws aren't in and the ground lift switch isn't even there. i'd suggest going to Fractal's website for info, rather than a gear store based in india. the Fractal AX8 page has the correct images: https://www.fractalaudio.com/ax8-amp-modeler-multi-effects/Thanks guys, I was looking at this picture (i'm not next to my unit currently) and there is no output 2. Maybe it's an old picture? lol