Hi all,
I googled and searched the forum but can't find the answer. I have a bit of hiss. I use wireless, axe3 and then to active matrix speakers. I know a bit about hiss and where to look, but 2 things I'd like to hear from you:
1) As an easy step I ordered a humbuster cable to go from wireless to axe fx. Now I read only about it being used to plug into the "outs" of the axe. Any point of using the cable between wireless and axe in on the rear or should I send it back?
2) I use the noisegate on the input of course when necessary, but I found the noisegate offset in thee global menu. It is set to zero. I am assuming that that is the standard setting? Or did I mess with it in the past and don't remember?
Thanks in advance.
Harm
I googled and searched the forum but can't find the answer. I have a bit of hiss. I use wireless, axe3 and then to active matrix speakers. I know a bit about hiss and where to look, but 2 things I'd like to hear from you:
1) As an easy step I ordered a humbuster cable to go from wireless to axe fx. Now I read only about it being used to plug into the "outs" of the axe. Any point of using the cable between wireless and axe in on the rear or should I send it back?
2) I use the noisegate on the input of course when necessary, but I found the noisegate offset in thee global menu. It is set to zero. I am assuming that that is the standard setting? Or did I mess with it in the past and don't remember?
Thanks in advance.
Harm