FX Loop Problem

[Rcharl]

I seem to be having issues with my FX loop. I insert an FX loop into my
chain and whenever I try to run an effect through the loop I lose all
signal. I have checked and rechecked my signal path and it is all correct.
But in order to troubleshoot I ran a known good cable by itself going from
FX Send to FX Return (L) and signal still disappears. Is there a level or
another step I am missing? Does Output 2 control volume in any way? (I have
had it on full to test still nothing) This is the first I have used the
effects loop in my Axe FX.. I ran tests on some of my other units using the
same setup and had no issues, Helix worked well, and did an Analog system.

Let me know what, if anything, I may be doing wrong.

 

[Severed]

Make sure the output level 2 on the front of the Axe is turned up?

 

[Rex]

Make sure the output level 2 on the front of the Axe is turned up?

Yes, turn it all the way up.

 

[Sorbz62]

What are you connected to?

 

[mr_fender]

Do you have anything in front of the FX loop panned? If the signal is panned hard right before the FX Loop block, you'll get no signal at the left out jack.