Mr. B
Member
@AlGrenadine:
Below I listed the steps I took to encounter the issue I referred to last Friday May 22nd.
Actually it doesn’t matter what I do. The problem keeps coming back after short time usage of the interface. Fracpad acts normal again after closing and re-opening the Fracpad application.
Concerning other apps: I only use this iPad for Fracpad. No other apps installed except for unremovable Apple stuff.
By the way: Fracpad keeps asking to switch on Bluetooth, while I’m using a USB connection. FYI: whether or not Bluetooth is switched on, the problem below remains the same.
I've send you an email titled "Fracpad interface doesn't update properly" containing screenshots of the log file and of the Options settings..
Hope this helps to find out what’s wrong.
Below I listed the steps I took to encounter the issue I referred to last Friday May 22nd.
Actually it doesn’t matter what I do. The problem keeps coming back after short time usage of the interface. Fracpad acts normal again after closing and re-opening the Fracpad application.
Concerning other apps: I only use this iPad for Fracpad. No other apps installed except for unremovable Apple stuff.
By the way: Fracpad keeps asking to switch on Bluetooth, while I’m using a USB connection. FYI: whether or not Bluetooth is switched on, the problem below remains the same.
I've send you an email titled "Fracpad interface doesn't update properly" containing screenshots of the log file and of the Options settings..
- Reset Log
- Reboot iPad and AX8
- Open Amp block
- Go to TAB GEQ
- Change from “pre-amp” to “post-amp”
- Change Amp block from X to Y
- Change from “5 band Mark” to “7 band Var”
- Change Amp block from Y to X
- Change from “pre-amp” to “post-amp”
- Go to TAB Basic
- Change Mid from 4.48 to 7.48
- Go to TAB GEQ
- Change from “post-amp” to “pre-amp”
- Change Amp block from X to Y
Hope this helps to find out what’s wrong.