PROGRAMMING A NOTE TO A FOOTSWITCH
1) Use the UP or DOWN footswitches to navigate to the bank you wish to use. You can change the settings for each of the 10 banks. In this example, let's select bank "00".
2) Press the footswitch that you wish to edit/assign. In this example, let's press the switch labeled "1". The light next to the footswitch will light up.
3) Press and hold the DOWN footswitch to enter preset programming mode. The green light labeled "SWITCH1/SWITCH2" will start flashing.
4) Press UP/ENTER to verify that you wish to edit this preset.
5) If your pedalboard features the factory defaults, the lights next to footswitches 1, 8, and 9 will be lit. Press and hold each of them to clear them. The lights will go off.
6) Press and hold the 10/0 footswitch, to tell the pedalboard that you are trying to assign a MIDI note value. The led lights up, indicating that you are choosing to assign a MIDI note.
7) Quickly press the 10/0 footswitch once to confirm your selection. The led will start blinking.
8) Use the numbered footswitches to enter the numerical value corresponding to the MIDI note you wish to assign. The values range from 0 to 127. For this example, press the "0" switch, which assigns the lowest note available. (C-2)
9) Confirm your selection by pressing the UP/ENTER footswitch.
10) Press and hold DOWN/ESCAPE to save your changes.
https://forum.ableton.com/viewtopic.php?t=197421
https://kb.musictribe.com/musickb/v...010-Can-I-Have-A-General-Programming-Overview